ATM switch fiber optic interface

Asynchronous Transfer Mode

Most ATM networks supporting SPVPs, SPVCs, and SVCs use the Private Network-to-Network Interface (PNNI) protocol to share topology information between switches and select a route through a network.

ATM Network Modules

Connecting Cisco ATM Network Modules to The NetworkATM-25 Network ModuleATM T3 and E3 Network ModulesATM OC-3 Network ModulesThe ATM-25 network module (see Figure 1) provides ATM traffic shaping for use with asymmetric digital subscriber line (ADSL) uplink speeds, and protocol support for permanent virtual circuit (PVC) environments. The network module provides full support for multiprotocol encapsulation over ATM Adaptive Layer 5 (RFC 1483), classic IP over ATM encapsul...See more on cisco Published: May 1, 2008Wikipedia

Asynchronous Transfer Mode - Wikipedia

An ATM network must establish a connection before two parties can send cells to each other. This is called a virtual circuit (VC). It can be a permanent virtual circuit (PVC), which is created administratively on the endpoints, or a switched virtual circuit (SVC), which is created as needed by the communicating parties. SVC creation is managed by signaling, in which the requesting party indicates the address of the receiving party, the type of service requested, and whatever traffic parameters may be applicable to th

Asynchronous Transfer Mode (ATM) Switching

An ATM network consists of a set of ATM switches interconnected by point-to-point ATM links or interfaces. ATM switches support two primary types of interfaces: UNI and NNI.

Upgrading fddi backbones to atm | Lightwave Online

For those seeking a proven, tested, and immediately available solution, there are two choices: an fddi switch or an Asynchronous Transfer Mode (atm) backbone. An fddi switch is a device that...

Asynchronous Transfer Mode ( ATM )

A typical small switch can connect between 16 and 32 computers. To permit data communication at high speed, each connection between a computer and an ATM switch uses a pair of optical fibers.

Buy FORE Systems STA-AMOD0249 OC-3 ATM Optical Interface

FORE Systems STA-AMOD0249 is an OC-3 (STM-1) multimode ATM optical interface module for FORE Systems ASX-series ATM switches, supporting 155.52 Mbps fiber connectivity.

Asynchronous Transfer Mode (ATM)

Asynchronous Transfer Mode (ATM) can be used as the underlying technology for Fiber Distributed Data Interface (FDDI), Synchronous Optical Network (SONET), and other high-speed

ATM Network Modules

To connect an ATM OC-3 network module to the network, insert a fiber-optic cable with one duplex SC connector (see Figure 15) or two simplex SC connectors (see Figure 16) into the ATM interface.

Architecture Design of an ATM Switch Based on a High Speed Network

One of the key issues that must be fulfilled to realize BISDN, is to develop high speed and high capacity ATM packet switches. For this, many technical problems must be investigated, such as

ATM Transceivers

The module is suited for use in low-cost, local area and wide area network (LAN/WAN) applications. It can be used as a network-end device interface in workstations, servers and storage devices, and in